Featured Products
Products See More
  Fiberglass Filament Yarn
  Geogrids/Geonets
  Fiberglass Insect Screen
  Glass Textile Wallcovering
  Fiberglass Mats
  Chopped Strands
  Woven Roving
  Fiberglass Mesh
  Drywall Joint Tape
  Glass Fiber Fabric/Cloth
  Fiberglass Roving
  Fiberglass Sleeving
  Geotextiles
  Geocells/Geowebs
  Geomembranes/Pond Liners
  Geocomposites
  Other Geosynthetics/Earthwork
  Engineering Fiber
  Geosynthetic Clay Liners/GCLs
  Geomat
  Drainage Net
  PVC Corner Mesh/Corner Bead
  Silicone Baking Mat
  Polyester Roofing Fabric
  Machines
 
Fiberglass
Geosynthetics
 
 
 
 
Featured Products  
44.How do I Install a Garden Waterfall?

 

Input Date::[2010/12/27 18:10:58]    From:Fibtex Co.,Ltd.

 
A garden waterfall can create a beautiful focal point in a garden, as well as provide interest in an otherwise flat landscape. There are two types of garden waterfall that do-it-yourself homeowners can install. The first is a pre-formed cascade unit and the second is a waterfall that flows over a building of natural stone with a waterproof liner.

Pre-formed cascade units are widely available and can be a good choice for a homeowner who wishes to install a garden waterfall in a minimum amount of time. The design work has already been done; therefore, the water tends to flow easily from one area to another. Some designs include falls within the unit; others have small areas for water plants. These units can be made of
fiberglass, plastic, cement, or stone, and water flow rates vary widely from system to system.

To install a pre-formed system, it is first important to understand flow rate. Larger flow rates can result in water loss from splashing. In this case it may be necessary to install a liner to catch extra water and direct it back to the pool. It is wise to start at the bottom when installing a series of cascade pools. Set the hose in place to disguise it before positioning the unit. The pump should be placed near the base of the waterfall to avoid excess water circulation in the pool. Set the cascade units into place loosely and run water through to get an idea of the finished affect.

Then, pack the soil foundations firmly and support with cement to affix them in their places. Ensure that there is enough clearance above the water level around the edges to avoid seepage. To finish the overall look of the garden waterfall, disguise the edges of the units with rocks, soil and plants.

A liner-constructed garden waterfall takes a bit more time and expertise to install at the outset, but can be more adaptable and unique than a pre-formed unit. The main goal is to construct a series of cascade units that end in a larger pool at the bottom of the series. Construction should be started at the bottom, with installation of purchased liners moving up to ensure a natural progression of water flow. As with cascade units, put the pump and hose in place, and make a trial run to check for excess leakage.

 
 Previous     Next
PRINT】 【TOP】【CLOSE】  

Copyright 2006-2011   Fibtex Co.,Ltd. All rights reserved. Management
            Registration No.:ICP-SD-07005441    Tel:0086 538 8489018    Fax:0086 538 8488028